added fluxo and hyprlock conf

hypr/hyprlock/network.sh

@@ -0,0 +1,65 @@
+#!/bin/bash
+
+# Set this variable to control the output
+# Set to "true" to show SSID, "false" to show "Connected"
+# show_ssid=false
+
+# Read the wifi-mode alias from hyprlock.conf
+show_ssid=$(grep -oP '^\$wifi-mode\s*=\s*\K\S+' ~/.config/hypr/hyprlock.conf)
+
+# Check if the SSID was successfully extracted else fallback?!
+if [ -z "$show_ssid" ]; then
+  show_ssid=false
+fi
+
+# Check if any Ethernet connection is active
+ethernet_connected=$(nmcli -t -f DEVICE,TYPE,STATE dev | grep -E 'ethernet:connected')
+
+# If Ethernet
+if [ -n "$ethernet_connected" ]; then
+    echo "󰈀  Ethernet"
+    exit 0
+fi
+
+# Get Wi-Fi connection status
+wifi_status=$(nmcli -t -f WIFI g)
+
+# Check if Wi-Fi is enabled
+if [ "$wifi_status" != "enabled" ]; then
+    echo "󰤮  Wi-Fi Off"
+    exit 0
+fi
+
+# Get active Wi-Fi connection details
+wifi_info=$(nmcli -t -f ACTIVE,SSID,SIGNAL dev wifi | grep '^yes')
+
+# If no active connection, show "Disconnected"
+if [ -z "$wifi_info" ]; then
+    echo "󰤮  No Wi-Fi"
+    exit 0
+fi
+
+# Extract SSID
+ssid=$(echo "$wifi_info" | cut -d':' -f2)
+
+# Extract signal strength
+signal_strength=$(echo "$wifi_info" | cut -d':' -f3)
+
+# Define Wi-Fi icons based on signal strength
+wifi_icons=("󰤯" "󰤟" "󰤢" "󰤥" "󰤨") # From low to high signal
+
+# Clamp signal strength between 0 and 100
+signal_strength=$((signal_strength < 0 ? 0 : (signal_strength > 100 ? 100 : signal_strength)))
+
+# Calculate the icon index based on signal strength
+icon_index=$((signal_strength / 25))
+
+# Get the corresponding icon
+wifi_icon=${wifi_icons[$icon_index]}
+
+# Output based on show_ssid variable
+if [ "$show_ssid" = true ]; then
+    echo "$wifi_icon  $ssid"
+else
+    echo "$wifi_icon  Connected"
+fi