# Anvil changelog ## 0.4.0 - Add **Mode**: **Replace** swaps the sub as before; **Enhance** keeps the original sub and adds the sine under it. - Add **NOTE** as a pitch source: Anvil plays a note you set, and the audio only starts and stops it. Add Key lock and Follow bends for AUDIO detection. - Detection holds its notes: a new note needs a steady pitch for 40 ms, octave jumps need 80 ms down and 200 ms up. Growls, wobbles and formant basses no longer flicker between notes. Follow bends brings back the old fast behaviour. - When detection is unsure, Anvil plays the original sub (Enhance: adds nothing) instead of a guessed note, and the NOTE readout shows **?**. - The editor opens on a MAIN page with Mode, Split, Sub level, Octave, Ghost, Keep and Output. **ADVANCED** in the header shows every control and Kick lock. - Projects from 0.3 load with Replace mode, AUDIO detection, and Key lock off. ## 0.3.0 - Add Ghost harmonics: **Ghost** and **Ghost from** add the sub's harmonics 2–10 above a chosen frequency, so phones hear the note. Anvil measures the patch's own harmonics above the split and fills only the ones that are missing. The sub level does not change. - Add **Phone**, a listen mode: mono, band-limited to 400 Hz–7 kHz. Not saved. - Show the patch's harmonics and the added ones in an inset in the scope. - Add Kick lock: with the kick in the sidechain, each kick ducks the sub (**Duck**, **Release**) and restarts it at Phase, shifted by **Offset** (āˆ’30 to +30 ms, also before the kick). - Add the offset **Audition**: steps the offset from āˆ’30 to +30 ms, 4 kicks each, shows how kick and sub summed per offset, and **Keep** takes the offset heard. - Anvil now has a sidechain input named Kick. Without Kick lock it is ignored. ## 0.2.0 - Change the CLAP ID to `io.narl.bass-foundry.anvil`. Hosts see this as a new plugin: delete the old `.clap` file, rescan, and add the plugin again in existing projects. ## 0.1.0 - Introduce Anvil, a sub anchor for bass music. - Replace the band below Split with a clean mono sine. Every note gets the same peak level and starts at the same phase, so switch-ups and kick hits line up. - Detect pitch and note starts from the audio with 80 ms lookahead, or follow MIDI notes sent to the effect. - Controls: Sub level, Split, Dynamics, Drive, Octave, Glide, Phase, Gate, Keep, Output, Retrigger, Snap to semitone, Bypass. Solo sub monitors only the new sub. - Note readout, level meters and an oscilloscope of the original low band against the new sub.